Dual reversing camera built into the STOP lamp lens for Mercedes Sprinter 314cdi 2016-2021 VW Crafter 2006-2016
• Mercedes Sprinter 314cdi 2016-2021
• VW Crafter 2006-2016
• 90-degree camera for looking backwards, e.g., instead of a mirror when driving forward
• 120-degree reversing camera directed more downwards for parking, equipped with IR LEDs
The cameras can operate in the CVBS NTSC system for older monitors or in the AHD system with a resolution of 1080P for monitors supporting this technology.
The function is switched using a loop.
The camera is mounted in the brake light - use the original lamp - replace the lens with a new one with the camera module.
Standard cameras equipped with an LED brake light may cause additional problems during installation - e.g., the brake light may not turn off completely, or it may flicker, so replacing just the lampshade is much safer, as the light remains original - factory.
A double 15-meter 4-PIN cable is included. If your monitor has RCA connectors, please purchase additional adapters available in our offer.
• Sensor: 1/3" CMOS
• Lens: f: 2.8mm
• Tightness: IP68
• Vibration resistance: 10G
• Connector: 4-PIN
• System: CVBS NTSC/AHD1080P
• Viewing angle: 90/120 degrees
• Built-in IR: 6 pcs
• B.L.C: Back light compensation (Auto)
• White Balance: Auto White Balance (Auto)
• Power Supply DC 12V (+/-10%) <3W
Depending on the monitor used, it is possible to view one or the other camera (switched using the buttons on the monitor), but usually the view from the 90-degree camera is permanently switched on for viewing as if in a mirror.
If reverse gear control is connected to the monitor, the monitor will automatically switch to the wide-angle reversing camera when reversing.
Split-screen monitors are also available that display both cameras simultaneously. In such a monitor, you can also use buttons to change the view to individual cameras and control automatic switching using reverse gear.
Very simple camera installation. Just remove the factory brake light cover and replace it with a new one with a camera module, connect the 4-PIN cable (video and power) to the monitor. If the monitor does not have a 4-PIN connector, use an RCA reduction.
In rare cases, in some vehicles, the power supply to the reversing light is not stable - there are signals from the computer testing the bulb, which may cause interference in the image or no image at all.
In such a case, a filter should be used. anti-interference device or, in extreme cases, a relay supplying clean voltage from another point of the installation.
Vrácení peněz při nedoručení
